Transmission Shift Lever and Selector Relay Lever to Model Year 2007 Assembly Overview

Transmission Shift Lever and Selector Relay Lever to Model Year 2007 Assembly Overview

• Grease bearing areas and slide surfaces with grease (G 000 450 02).





1 Selector Mechanism Cover

• Removing and installing with transmission installed, refer to => [ Selector Shaft ] Selector Shaft

2 Selector Shaft

• Removing and installing with transmission installed, refer to => [ Selector Shaft ] Selector Shaft

3 Bushing

4 Retaining Washer

• Removing

5 Shaft Seal

• Replace, refer to => [ Selector Shaft Seal ] Selector Shaft Seal

6 Retaining Washer

7 Control Cable Retainer

• For shift cable to transmission shift lever - 4 - => [ Control Cable Retainer ] Shift Cable and Selector Cable to Model Year 2007 Assembly Overview

• Allocation => [ Allocation of Control Cable
Retainers ] Shift Cable and Selector Cable to Model Year 2007 Assembly Overview

8 Nut

• Replace

• 23 Nm

• Self-locking

9 Transmission Shift Lever

• With balance weight

• Insert so that master spline aligns with shift rod

• Installation location

• Different diameters of the control cable retainer mounting pin => [ Starting in 06/2006, Smaller
Mounting Pin Diameter for the Shift Cable Retainer ] Shift Cable and Selector Cable to Model Year 2007 Assembly Overview

10 Retaining Washer

11 Control Cable Retainer

• For the selector cable on the selector relay lever - 2 - => [ Control Cable Retainer ] Shift Cable and Selector Cable to Model Year 2007 Assembly Overview

• Allocation => [ Allocation of Control Cable
Retainers ] Shift Cable and Selector Cable to Model Year 2007 Assembly Overview

• Release to adjust selector mechanism => [ Release cable retainer for
selector and shift cables as follows: ] Adjustments

12 Selector Relay Lever

• Installation location

13 Slide Shoe

14 Bushing

15 Lock Elbow

• For adjustment of shift mechanism, refer to => [ Shift Mechanism, Adjusting ] Adjustments

Remove the Lock Washer for the Selector Relay Lever





- Lift on the circlip - arrow -.

Installing the Transmission Shift Lever





- When positioning the transmission shift lever, make sure the gap - arrow A - is placed over the missing selector shaft teeth - arrow B -.

Installation Position of Transmission Shift Lever/Selector Relay Lever





1 Transmission shift lever with balance weight
2 The selector relay lever engages in the transmission shift lever slide rail via the slide shoe - arrow -.

- Lubricate the slide rail and slide shoe - arrow - with grease (G 000 450 02).