CVT RE0F09B

P0746 PRESSURE CONTROL SOLENOID A





Description
The line pressure solenoid valve regulates the oil pump discharge pressure to suit the driving condition in response to a signal sent from the TCM.




DTC Logic

DTC DETECTION LOGIC






DTC CONFIRMATION PROCEDURE

CAUTION:
Always drive vehicle at a safe speed.

NOTE:
If "DTC CONFIRMATION PROCEDURE" has been previously performed, always turn ignition switch OFF.
Then wait at least 10 seconds before performing the next test.
1.CHECK DTC DETECTION
With CONSULT-III
1. Turn ignition switch ON.
2. Select "DATA MONITOR".
3. Start engine and maintain the following conditions for at least 10 consecutive seconds. Test start from 0 km/h (0 MPH).





With GST
Follow the procedure "With CONSULT-III".
Is "P0746" detected?
YES - Go to CVT RE0F09B.
NO - Check intermittent incident. Refer to Intermittent Incident.




Diagnosis Procedure
1.CHECK LINE PRESSURE
Perform line pressure test. Refer to CVT RE0F09B.
Is the inspection result normal?
YES - GO TO 2.
NO - Repair or replace damaged parts. Refer to CVT RE0F09B.
2.CHECK LINE PRESSURE SOLENOID VALVE
1. Turn ignition switch OFF.
2. Disconnect CVT unit harness connector.
3. Check line pressure solenoid valve. Refer to CVT RE0F09B.
Is the inspection result normal?
YES - GO TO 3.
NO - Replace transaxle assembly. Refer to Exploded View.
3.CHECK SECONDARY SPEED SENSOR SYSTEM
Check secondary speed sensor system. Refer to CVT RE0F09B.
Is the inspection result normal?
YES - GO TO 4.
NO - Repair or replace damaged parts.
4.CHECK PRIMARY SPEED SENSOR SYSTEM
Check primary speed sensor system. Refer to CVT RE0F09B.
Is the inspection result normal?
YES - GO TO 5.
NO - Repair or replace damaged parts.
5.DETECT MALFUNCTIONING ITEMS
Check TCM connector pin terminals for damage or loose connection with harness connector.
Is the inspection result normal?
YES - Replace TCM. Refer to Exploded View.
NO - Repair or replace damaged parts.




Component Inspection (Line Pressure Solenoid Valve)
1.CHECK LINE PRESSURE SOLENOID VALVE





Check resistance between CVT unit terminal 2 and ground.





Is the inspection result normal?
YES - INSPECTION END
NO - Replace transaxle assembly. Refer to Exploded View.