Removal And Installation

REAR TRIM

Removal and Installation


REMOVAL

REAR PARCEL SHELF SIDE FINISHER
1.Remove tonneau cover (with tonneau cover).





2.Slide rear parcel shelf side finisher toward the direction of the arrow to remove.

Broken triangle indicates : Pawl

REAR PARCEL SHELF COVER





Remove rear parcel shelf cover LH with remover tool as shown in the figure.

Broken circle indicates : Clip

REAR PARCEL SHELF FINISHER HOLDER
1.Fully open rear parcel shelf finisher holder in three steps as shown in the figure below. (approximately 45
degree)
2.Pull back to remove.





SEATBACK CENTER FINISHER
1.Remover center console assembly. Removal And Installation.
2.Remove rear side finisher. Coupe.
3.Disconnect seatback center finisher fixing clips, and then pull it up to remove.
REAR PARCEL SHELF FINISHER
1.Remove seatback center finisher.





2.Remove the clips (A) with a remover tool.
3.Hold rear parcel shelf finisher (1) from both sides, and then pull it back to remove.

Broken circle indicates : Clip
White arrow indicates : Vehicle front

REAR PARCEL SHELF BRACKET
1.Remove rear parcel shelf finisher.





2.Remove rear parcel shelf bracket (1) mounting bolts (A) (LH and
RH).

White arrow indicates : Vehicle front

BACK PANEL FINISHER ASSEMBLY
1.Remove luggage floor spacer front. Exploded View.
2.Remove rear side finisher. Refer Coupe.
3.Remove rear pillar finisher. Coupe.





4.Remove the clips (A) fixing the back panel finisher assembly (1)
to the rear parcel shelf bracket.

Broken circle indicates : Clip
White arrow indicates : Vehicle front

5.Pull back panel finisher assembly to remove.

INSTALLATION

Note the following item, and then install in the reverse order of removal.

CAUTION:
Check that clips are securely fitted in panel holes on body when installing, and then press them in.