Vehicle Stability Control System

BRAKE CONTROL: VEHICLE STABILITY CONTROL SYSTEM: DIAGNOSTIC TROUBLE CODE CHART

DIAGNOSTIC TROUBLE CODE CHART

HINT:
- If a trouble code is displayed during the DTC check, check the circuit indicated by the DTC. For details of each code, refer to the "Refer to" for the respective DTC in the DTC chart.
- Inspect the appropriate fuses and relays before investigating the trouble areas as shown in the table below.

DTC Chart of ABS:

C0200/31 - C0279/12:

C1225/25 - C1243/43:

C1244/44 - C1254/54:

C1256/56 - C1381/97, U0073/94 - U0124/95:

*1, *2:
Even after the trouble areas are repaired, the ABS warning light will not go off unless the following operations are performed.

- *1:
(a) Drive the vehicle at 20 km/h (12 mph) for 30 seconds or more and check that the ABS warning light goes off.
(b) Clear the DTC.
- *2:
(a) Keep the vehicle in a stationary condition for 5 seconds or more and depress the brake pedal lightly 2 or 3 times.
(b) Repeat the above operation 3 times or more and check that the ABS warning light goes off.
(c) Clear the DTC.

HINT:
- In some cases, the Techstream cannot be used when the ABS warning light remains on.
- When U0073/94, U0100/65, U0123/62, U0124/95 or U0126/63 is output, inspect and repair the trouble areas indicated by these codes first.

*3: The skid control buzzer sounds.
*4: for 4WD
*5: w/ A-TRAC Switch
*6: w/o A-TRAC Switch

DTC Chart of VSC:

C1201/51 - C1290/56:

C1336/39 - C1380/64, U0100/65 - U0126/63:

*4: for 4WD

HINT: In some cases, Techstream cannot be used when the VSC OFF indicator light remains on.