Operation CHARM: Car repair manuals for everyone.

Power Source Mode does not Change to ON (ACC)





THEFT DETERRENT / KEYLESS ENTRY: SMART KEY SYSTEM (for Start Function): Power Source Mode does not Change to ON (ACC)
- Power Source Mode does not Change to ON (ACC)

DESCRIPTION

When the engine switch is pushed with the key in the cabin, the power management control ECU receives signals to switch the power source mode.

HINT
To allow use of the Techstream to inspect the push-button start function when the engine switch is off, repeatedly open and close any of the doors. Repeatedly opening and closing a door establishes communication between the Techstream and power management control ECU (opening and closing a door can also be simulated by operating a door courtesy light switch).

WIRING DIAGRAM

Refer to "Power Source Mode does not Change to on (IG and ACC)" Power Source Mode does not Change to ON (IG and ACC).

INSPECTION PROCEDURE

NOTICE:
* When using the Techstream with the engine switch off to troubleshoot: Connect the Techstream to the vehicle and turn a courtesy light switch on and off at 1.5 second intervals until communication between the Techstream and vehicle begins.
* Before performing the inspection, check that there are no problems related to the CAN communication system and LIN communication system.
* Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE

1. CHECK HARNESS AND CONNECTOR (BATTERY - POWER MANAGEMENT CONTROL ECU) B2271

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

2. CHECK HARNESS AND CONNECTOR (POWER MANAGEMENT CONTROL ECU - BODY GROUND) B2271

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

3. INSPECT DRIVER SIDE JUNCTION BLOCK ASSEMBLY (ACC RELAY) B2274

NG -- REPLACE MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK ASSEMBLY)
OK -- Continue to next step.

4. CHECK HARNESS AND CONNECTOR (POWER MANAGEMENT CONTROL ECU - DRIVER SIDE JUNCTION BLOCK ASSEMBLY) B2274

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

5. CHECK HARNESS AND CONNECTOR (DRIVER SIDE JUNCTION BLOCK ASSEMBLY - BODY GROUND) B2271

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

6. CHECK POWER MANAGEMENT CONTROL ECU B2274

NG -- REPLACE POWER MANAGEMENT CONTROL ECU Removal
OK -- Continue to next step.

7. CONFIRMATION TEST Power Source Mode does not Change to ON (IG and ACC)

NG -- CHECK RELAY CONTACT SIDE CIRCUIT

OK -- USE SIMULATION METHOD TO CHECK How To Proceed With Troubleshooting