Alarm Module: Service and Repair

Passive Anti-Theft System (PATS) Module

Removal

NOTE:
If the PATS module is to be replaced then T4 must be connected and the correct procedures adhered to, prior to the battery disconnection.
1 Disconnect the battery ground cable. For additional information, refer to Specifications Service and Repair
2 Remove the RH A-pillar upper trim panel. For additional information, refer to A-Pillar Trim Panel Pillar Trim
3 Remove the RH B-pillar upper trim panel. For additional information, refer to B-Pillar Upper Trim Panel B-Pillar Upper Trim Panel
4 Remove the RH C-pillar upper trim panel. For additional information, refer to C-Pillar Upper Trim Panel C-Pillar Upper Trim Panel




5 Remove the RH sun visor.
- Remove the screw covers.
- Remove the 2 screws.




6 Remove the sun visor retaining clip.
- Release the screw cover.
- Remove the screw.




7 Remove the RH passenger assist handles.
- Carefully release the 4 screw covers.
- Remove the 4 screws.




8 Remove the rear headliner trim panel.
- Release the 7 clips.




9 Release the RH side of the headliner.
- Carefully release the 4 clips.





10 Remove the PATS module.
- Disconnect the electrical connector.
- Remove the 2 bolts.

Installation
1 Install the PATS module.
- Connect the electrical connector.
- Tighten the bolts to 10 Nm (7 lb.ft).
2 Secure the RH side of the headliner.
- Carefully secure the clips.
3 Install the rear headliner trim panel.
- Secure the clips.
4 Install the RH passenger assist handles.
- Install the screws.
- Install the screw covers.
5 Install the sun visor retaining clip.
- Install the screw.
- Install the screw cover.
6 Install the RH sun visor.
- Install the screws.
- Install the screw covers.
7 Install the RH C-pillar upper trim panel. For additional information, refer to C-Pillar Upper Trim Panel C-Pillar Upper Trim Panel
8 Install the RH B-pillar upper trim panel. For additional information, refer to B-Pillar Upper Trim Panel B-Pillar Upper Trim Panel
9 Install the LH A-pillar upper trim panel. For additional information, refer to A-Pillar Trim Panel Pillar Trim

10 Connect the battery ground cable. For additional information, refer to Specifications Service and Repair

11 Initiate a new PATS module using T4.