Tire Pressure Module: Service and Repair

Low Tire Pressure Module

Removal

NOTE:
If the tire pressure module is to be replaced then T4 must be connected and the correct procedures adhered to, prior to battery disconnection.
1 Disconnect the battery ground cable. For additional information, refer to Specifications Service and Repair
2 Remove the LH A-pillar upper trim panel. For additional information, refer to A-Pillar Trim Panel Pillar Trim
3 Remove the LH B-pillar upper trim panel. For additional information, refer to B-Pillar Upper Trim Panel B-Pillar Upper Trim Panel
4 Remove the LH C-pillar upper trim panel. For additional information, refer to C-Pillar Upper Trim Panel C-Pillar Upper Trim Panel




5 Remove the LH sun visor.
- Remove the cover.
- Remove the 2 screws.
- Disconnect the electrical connector.




6 Remove the sun visor retaining clip.
- Release the screw cover.
- Remove the screw.




7 Remove the LH passenger assist handles.
- Carefully release the 6 screw covers.
- Remove the 6 screws.




8 Release the LH side of the headliner.
- Release the 6 clips.




9 Remove the low tire pressure module.
- Disconnect the 2 electrical connectors.
- Remove the 2 bolts.

Installation
1 Install the low tire pressure module.
- Tighten the bolts to 10 Nm (7 lb.ft).
- Connect the electrical connectors.
2 Secure the LH side of the headliner.
- Carefully secure the clips.
3 Install the LH passenger assist handles.
- Install the screws.
- Install the screw covers.
4 Install the sun visor retaining clip.
- Install the screw.
- Install the screw cover.
5 Install the LH sun visor.
- Install the screws.
- Install the screw covers.
- Connect the electrical connector.
6 Install the LH C-pillar upper trim panel. For additional information, refer to C-Pillar Upper Trim Panel C-Pillar Upper Trim Panel
7 Install the LH B-pillar upper trim panel. For additional information, refer to B-Pillar Upper Trim Panel B-Pillar Upper Trim Panel
8 Install the LH A-pillar upper trim panel. For additional information, refer to A-Pillar Trim Panel Pillar Trim
9 Connect the battery ground cable. For additional information, refer to Specifications Service and Repair