Removal

2UR-FSE FUEL: INJECTOR DRIVER: REMOVAL

NOTICE:
While the battery is connected, even if the power switch is OFF, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal or open/ close the doors while the battery is connected.

1. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY Removal

2. REMOVE DECK TRIM SIDE BOARD LH (w/o Spare Tire) Removal

3. REMOVE BATTERY SERVICE HOLE COVER LH Removal

4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
* w/ Navigation System (for HDD):
After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal:

* When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

5. REMOVE SERVICE PLUG GRIP

(a) Remove the service plug grip Removal.

6. REMOVE V-BANK COVER SUB-ASSEMBLY Removal

7. REMOVE AIR CLEANER INLET COVER SUB-ASSEMBLY Removal

8. REMOVE ENGINE ROOM SIDE COVER LH Removal

9. REMOVE ENGINE ROOM SIDE COVER RH Removal

10. REMOVE NO. 1 AIR CLEANER INLET Removal

11. REMOVE INTAKE AIR CONNECTOR PIPE Removal

12. REMOVE AIR CLEANER ASSEMBLY LH Removal

13. REMOVE AIR CLEANER ASSEMBLY RH Removal

14. DISCONNECT NO. 1 MOTOR COOLING PIPE Removal

15. REMOVE SKID CONTROL ECU Removal

16. DISCONNECT NO. 3 ENGINE ROOM RELAY BLOCK Removal

17. DISCONNECT BRAKE FLUID RESERVOIR Removal

18. REMOVE SKID CONTROL ECU BRACKET Removal

19. REMOVE ENGINE COVER SUB-ASSEMBLY LH Removal

20. REMOVE NO.6 COVER SUB-ASSEMBLY Removal

21. REMOVE ENGINE ROOM ECU COVER Removal

22. REMOVE OUTLET ENGINE ROOM ECM DUCT Removal

23. DISCONNECT HYBRID VEHICLE CONTROL ECU Removal

24. DISCONNECT NO. 2 CONNECTOR HOLDER Removal

25. DISCONNECT ECM CONNECTOR Removal

26. DISCONNECT ENGINE WIRE HARNESS Removal

27. REMOVE INJECTOR DRIVER

(a) Disconnect the 8 injector driver connectors.

(1) Disconnect the 6 connectors with wire harness locks and the 2 connectors without wire harness locks from the 2 injector drivers.

HINT
To release each connector lock, push the claw downward ("Release" in the illustration) and move the lock lever ("Move" in the illustration).

(b) Remove the 2 bolts, 2 nuts and 2 injector drivers with bracket.

NOTICE:
Be careful not to drop or strike the injector driver.