Selector Mechanism Assembly Overview

Selector Mechanism Assembly Overview





1 Selector cover with knob

• Do not remove knob without reason. For emergency release, only the cover needs to be unclipped --> [ Selector Lever Emergency Release ] Service and Repair.

• Before removing handle, pull button out past its rest position and secure it with a cable tie or appropriate wire. This will prevent the button from being accidentally pressed into the knob.

• If button is pressed into removed handle

- Before installing knob, pull out button past felt pressure point.

• To release shift lever handle lock push upward on locking sleeve at bottom of shift lever handle.

2 Selector mechanism with selector lever

• Removing and installing --> [ Selector Mechanism with Selector Lever ] Removal and Replacement

3 Bolt with spring

• 3 Nm

4 Pin

• Removing --> [ Selector Lever Cable ] Removal and Replacement

• Do not grease

5 Locking plate

• Always replace after removing

6 Nut

• 9 Nm

• Qty. 4

7 Selector lever housing

• With seal

8 Selector lever cable

• Cable must not be greased

• Removing and installing --> [ Selector Lever Cable ] Removal and Replacement

• Checking --> [ Selector Lever Cable, Checking ] Procedures

• Adjusting --> [ Selector Lever Cable, Adjusting ] Adjustments

9 Hex nut with washer

• 8 Nm

• Qty. 4