Installation

INTERIOR: REAR SUNSHADE ASSEMBLY: INSTALLATION

INSTALLATION
HINT: A bolt without a torque specification is shown in the standard bolt chart Standard Bolt - Specified Torque For Standard Bolts.





1. INSTALL REAR SUNSHADE ASSEMBLY
(a) Temporarily install the rear sunshade assembly withe the bolt labeled A.
(b) Install the 4 bolts and tighten the bolt labeled A.
2. INSTALL NO. 2 PACKAGE TRAY TRIM PANEL ASSEMBLY





(a) Attach the 5 claws and 3 clips to install the panel.
3. INSTALL STEREO COMPONENT SPEAKER ASSEMBLY Installation
4. INSTALL REAR NO. 4 AIR DUCT (w/ Rear Cooler) Installation
5. INSTALL REAR NO. 5 AIR DUCT (w/ Rear Cooler) Installation
6. INSTALL NO. 2 ROOF SIDE AIR DUCT LH (w/ Rear Cooler) Installation
7. INSTALL NO. 2 ROOF SIDE AIR DUCT RH (w/ Rear Cooler) Installation
8. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY
(a) w/ Rear Cooler:
Connect the solar sensor connector.





(b) for Fixed Seat Type, for Power Seat:
Pass the 3 rear seat belt floor anchors through the panel.





(c) for Ottoman:
Pass the 2 rear seat belt floor anchors through the panel.
(d) Insert the rear part of the panel into the rear sunshade.
(e) Attach the 2 clips and install the package tray trim panel.





(f) for Fixed Seat Type, for Power Seat:
Attach the 4 claws to install the 3 belt guides.
(g) for Ottoman Seat:
Attach the 4 claws to install the 2 belt guides.
9. INSTALL INNER ROOF SIDE GARNISH LH Installation
10. INSTALL INNER ROOF SIDE GARNISH RH Installation
11. INSTALL REAR SEAT SIDE GARNISH LH Installation
12. INSTALL REAR SEAT SIDE GARNISH RH Installation
13. INSTALL REAR DOOR SCUFF PLATE LH Installation
14. INSTALL REAR DOOR SCUFF PLATE RH Installation
15. INSTALL REAR SEAT ASSEMBLY (for Fixed Seat Type)
(a) Install the rear seat Installation.
16. INSTALL REAR SEAT ASSEMBLY (for Power Seat)
(a) Install the rear seat Installation.
17. INSTALL REAR SEAT ASSEMBLY (for Ottoman)
(a) Install the rear seat Installation.
18. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

19. INSTALL BATTERY SERVICE HOLE COVER LH Installation
20. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY Installation
21. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light Diagnosis System.