Removal

DOOR / HATCH: HOOD LOCK CONTROL CABLE ASSEMBLY: REMOVAL

1. REMOVE COOL AIR INTAKE DUCT SEAL Removal

2. REMOVE ENGINE ROOM SIDE COVER Removal

3. REMOVE FRONT UPPER FENDER PROTECTOR Removal

4. REMOVE RADIATOR GRILLE PROTECTOR Removal

5. REMOVE FRONT BUMPER ASSEMBLY Removal

6. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System) Removal

7. REMOVE LOW PITCHED HORN ASSEMBLY Removal

8. REMOVE HOOD LOCK CONTROL CABLE COVER

(a) Remove the 3 screws.





(b) Disengage the clamp and remove the hood lock control cable cover.

9. REMOVE HOOD LOCK NUT CAP

(a) Using a screwdriver, remove the hood lock nut cap as shown in the illustration.





HINT
Tape the screwdriver tip before use.

10. REMOVE HOOD LOCK ASSEMBLY

(a) Remove the 2 bolts and hood lock nut.





(b) Disconnect the hood lock control cable assembly.





(c) Disconnect the connector and remove the hood lock assembly.

11. REMOVE FRONT DOOR SCUFF PLATE Removal

12. REMOVE FRONT DOOR OPENING TRIM COVER Removal

13. REMOVE SIDE INSTRUMENT PANEL Removal

14. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Removal

15. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

(a) Disengage the 3 claws.





(b) Disconnect the hood lock control cable and remove the hood lock control lever.

16. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY

(a) Tie a string to the end of the hood lock control cable assembly as shown in the illustration.









NOTICE:
Use a length of string long enough to pass through the engine compartment.

(b) Disengage the clamp and remove the hood lock control cable assembly as shown in the illustration.