B1010

DTC B1010

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor
DTC B1010 08
- System Sensors Data Mismatch Signal Invalid

Diagnostic Fault Information






Circuit/System Description

The folding top control (FTC) module detects a switch is not in the proper state when compared to other switches.

Conditions for Running the DTC

When the FTC module is active and being commanded to move.

Conditions for Setting the DTC

* The position and direction of the folding top when the fault occurs will determine whether DTC B1010 08 will set or another folding top DTC will set.
* Missing or wrong input signals while the top is running.

Action Taken When the DTC Sets

The top is disabled.

Conditions for Clearing the DTC

The fault is no longer present and the top completes one cycle.

Diagnostic Aids

* A weak battery may cause DTC B1010 08 to set.
* The conditions that cause DTC B1010 08 to set may also set other folding top DTCs.

Reference Information
Schematic Reference

Folding Top Schematics [1][2]Convertible Top
Connector End View Reference

Component Connector End Views Connector End Views By Name
Description and Operation

Power Folding Top Description and Operation Power Folding Top
Electrical Information Reference

* Circuit Testing Circuit Testing
* Connector Repairs Connector Repairs
* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections
* Wiring Repairs Wiring Repairs

Scan Tool Reference

Control Module References Programming and Relearning for scan tool information

Circuit/System Verification

1. Verify DTC B1296, B1307, B1325, B1335, B1345, B1395, B316A, B3602, B3669, B366A, B366B, B366C, B366D, B366E, B3674, B3675, B367A, B367B, B367F, B3680, B3683, or B3685 is not set.

• If any of the DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle Diagnostic Trouble Code (DTC) List - Vehicle.

2. Ignition ON, observe the scan tool Folding Top Module Inputs parameters. The parameters should match the information in the Folding Top Switch Position Matrix Folding Top Switch Position Matrix.

• If a folding top switch does not match the Folding Top Switch Position Matrix, perform the appropriate DTC diagnostic:

* S1 inoperative-Refer to DTC B1296 B1296
* S2 inoperative-Refer to DTC B3669 B3669
* S3 inoperative-Refer to DTC B367B B367B and DTC B1395 B1395
* S4 inoperative-Refer to DTC B367A B367A and DTC B1395 B1395
* S9 inoperative-Refer to DTC B366E B366E
* S10 inoperative-Refer to DTC B366D B366D
* S11 inoperative-Refer to DTC B366B B366B
* S12 inoperative-Refer to DTC B366A B366A
* S13 inoperative-Refer to DTC B367F B367F
* S14 inoperative-Refer to DTC B1307 B1307
* S17 inoperative-Refer to DTC B3683 B3683
* S18 inoperative-Refer to DTC B3685 B3685
* S19 inoperative-Refer to DTC B366C B366C